You can display information about the projector and input sources by viewing the Info menu. However, you cannot change any settings in the menu.
Note:
Available settings depend on the current input source. The lamp
usage timer does not register any hours until you have used the
lamp for at least 10 hours.
| Information item | Description |
|---|---|
| Projector Info | See the table below |
| Version | Displays the projector's firmware version |
| Temp Warning Info | Displays various high temperature warnings |
|
Power On/Off History
(EX9240) |
Displays the projector's power on and power off history |
Projector Info menu
| Information item | Description |
|---|---|
| Lamp Hours | Displays the number of hours (H) the lamp has been used in Power Consumption modes; if the information is displayed in yellow, obtain a genuine Epson replacement lamp soon |
| Source | Displays the name of the port to which the current input source is connected |
| Input Signal | Displays the input signal setting of the current input source |
| Resolution | Displays the resolution of the current input source |
| Refresh Rate | Displays the refresh rate of the current input source |
| Sync Info | Displays information that may be needed by a service technician |
| Status | Displays information about projector problems that may be needed by a service technician |
| Serial Number | Displays the projector's serial number |
| Event ID | Displays the Event ID number corresponding to a specific projector problem; see the list of Event ID codes |