Transferring Settings from a USB Flash Drive

After saving projector settings to a USB flash drive, you can transfer them to another projector of the same model.
Note: Make sure the USB flash drive contains only a single settings transfer from another projector of the same model. The settings are contained in a file called pjconfdata.bin. If the drive contains other files, the transfer may not complete correctly.

Do not adjust image settings on a projector until after you transfer settings to it. Otherwise, you may have to repeat your adjustments.

  1. Turn off the projector and unplug the power cord from the projector's power inlet.
  2. Insert the flash drive into the USB-A port.

    Note: Connect the flash drive directly to the projector. Do not use a hub or your settings may not be saved correctly.
  3. Press and hold the Menu button on the control panel or remote control as you connect the power cord to the projector's power inlet.

  4. When all of the projector lights turn on, release the Menu button.
    The lights flash to indicate that settings are transferring to the projector. When the lights stop flashing, the power light turns blue and the projector enters standby mode.
    Do not unplug the power cord or remove the flash drive while the lights are flashing. This could damage the projector.
  5. Once the projector enters standby mode, remove the flash drive.
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use