Installation Settings - Installation Menu

Settings on the Installation menu let you set up your projector for your installation environment. The available settings depend on the currently selected input source and other settings.
Note: Reset to Defaults is not displayed when projecting in Content Playback mode. Selecting Reset Installation Settings does not reset Digital Zoom or Image Shift settings.


Setting Options Description
Fixed Installation On

Off

Set to On if you installed the projector in a fixed location
Test Pattern Displays a test pattern to assist in focusing and zooming the image and correcting image shape
Setting Plate Installation Guide Displays an on-screen guide to assist with installing the projection screen when you have installed the projector on a wall
Vertical Installation Yes

No

Set to Yes if you installed the projector in a vertical position
Projection Front

Rear

Front/Upside Down

Rear/Upside Down

Selects the way the projector faces the screen so the image is oriented correctly
Geometry Correction H/V-Keystone

Quick Corner

Arc Correction

Point Correction

Memory

Adjusts image shape to rectangular (horizontally and vertically)

H/V Keystone: lets you manually correct horizontal and vertical sides

Quick Corner: select to correct image shape and alignment using an on-screen display

Arc Correction: select to adjust the curve or arc of the horizontal and vertical sides

Point Correction: select to divide the projected image into a grid and correct distortion by moving a selected point

Memory: controls memory functions for current image shape settings
  • Save Memory: saves the current image shape as a memory setting
  • Load Memory: loads a saved image shape memory
  • Rename Memory: renames a saved image shape memory
  • Erase Memory: deletes a saved image shape memory
  • Reset Memory: resets all the image shape memory settings
Digital Zoom Varying levels available Adjusts the size of the projected image
Image Shift Varying positions available Adjusts the position of the projected image
Connect ELPCB02 On

Off

Set to On to switch the input source between the HDMI2 port and HDMI3 port each time you press the HDMI2 button on the optional interface box
Remote Receiver Front/Rear

Front

Rear

Off

Limits reception of remote control signals by the selected receiver; Off turns off all receivers
Screen Type 4:3

16:6

16:9

16:10

21:9

Sets the aspect ratio to fit the image on the projection surface (setting only displayed when Content Playback is Off)
Screen Position Varying positions available Shifts the image position on the screen
High Altitude Mode On

Off

Regulates the projector's operating temperature at altitudes above 4921 feet (1500 m)
Source Displays settings saved for each input source
Blanking Top

Bottom

Left

Right

Hides an area of the projected image that you select (setting only displayed when Content Playback is Off)
Reset to Defaults Resets all settings for the current input source (setting only displayed when Content Playback is Off)
Reset Installation Settings Resets all settings on the Installation menu to their default values except for the following:
  • Digital Zoom
  • Image Shift
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use