Your ultra-short throw projector is designed to be
installed on a wall (with a wall mount)
or vertically on a table (with a
table mount) to create an interactive tabletop
workspace.
Note: A Touch
Unit is optional and must be installed for finger touch operation.
Finger touch operation is available only if the projector is
installed on a wall (with a wall mount) and projecting from the
front of the wall, or vertically on a table (with a table mount)
and projecting from the top of the table.
Keep these considerations in mind as you select a
projector location:
- Follow the
instructions in the online Installation Guide to install the projector.
- Leave
plenty of space around and under the projector for ventilation, and
do not place it on top of or next to anything that could block the
vents.
- If you are using the projector at altitudes above
4921 feet (1500 m), set the High
Altitude Mode setting to On in the projector's Installation menu to
ensure the projector's internal temperature is regulated
properly.
- Position
the projector within reach of a grounded electrical outlet or
extension cord.
- If installing vertically on a table, a commercially
available mount compatible with the VESA Mounting Interface
Standard (100 x 100 mm) is required.
- If installing on a wall, the wall mount (V12HA06A05)
is required.
- For finger touch, make sure the projection surface
is flat, smooth, and unwarped with no more than 0.2 inch (5
mm) of unevenness in any direction.
- Place the projector so it squarely faces the screen,
not at an angle. If you cannot install the projector squarely
facing the screen, correct any resulting image distortion using the
projector controls.
- Try not to set up the projector in locations subject
to high humidity and dust, or in locations subject to smoke from
fires or tobacco smoke.