Turning Off the Projector

Before turning off the projector, shut down any computer connected to it so you can see the computer display during shutdown.
Note: Turn off this product when not in use to prolong the life of the projector. Laser life will vary depending upon mode selected, environmental conditions, and usage. Brightness decreases over time.
  1. Press the power button on the projector or remote control.
    The projector displays a shutdown confirmation screen.


  2. Press the power button again. (To leave it on, press any other button.) The projector beeps twice, the laser turns off, and the Status light turns off.
    Note: If the Light Source Calibration setting is set to Run Periodically in the projector's Management menu, light source calibration starts automatically if you turn off the projector and the following conditions are present:
    • 100 hours have passed since the last light source calibration.
    • You have used the projector continuously for at least 20 minutes.
  3. To transport or store the projector, make sure the On/Standby light is blue (not flashing) and the Status light is off, then unplug the power cord.


    Caution:
    To avoid damaging the projector or laser, never unplug the power cord when the Status light is on or flashing.
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use