Normally the projector detects and optimizes the input signal settings automatically. If you need to customize the settings, you can use the Signal menu. The available settings depend on the currently selected input source.
Note: You can
restore the default settings of the Position, Tracking, and Sync settings by pressing the Auto button on the remote control.
To change settings for an input source, make sure the source is connected and select that source.
| Setting | Options | Description |
|---|---|---|
| Resolution | Auto
Wide Normal |
Sets the input signal resolution if not detected automatically using the Auto option |
| Aspect | See the list of available aspect ratios | Sets the aspect ratio (width-to-height ratio) for the selected input source |
| Tracking | Varying levels available | Adjusts signal to eliminate vertical stripes in computer images |
| Sync. | Varying levels available | Adjusts signal to eliminate fuzziness or flickering in computer images |
| Position | Up, down, left, right | Adjusts the image location on the screen |
| Auto Setup | On
Off |
Automatically optimizes computer image quality (when On) |
| Overscan | Auto
Off 4% 8% |
Changes the projected image ratio to make the edges visible by a selectable percentage or automatically when using an HDMI input source |
| Advanced | Video Range | Sets the video range to match the setting of the device connected to the HDMI input port. |
| Video Signal | Specifies the signal type from the input sources connected to the video ports. Select Auto to detect signals automatically. | |
| Reset | — | Resets all settings in the Signal menu to their defaults |