| Blue |
Normal operation. |
| Flashing blue |
Warming up, shutting down, or initializing the
projector. Remote control operations may be disabled when the light
is flashing blue. |
| Off |
Standby or sleep mode. |
| Orange |
Projector has overheated and turned off. Leave it
turned off to cool down and wait about five minutes.
- Make sure that the vents and air filter are not
clogged with dust or obstructed by nearby objects.
- Make sure the environmental temperature is not too
hot.
- Clean or replace the air filter.
- If operating the projector at high altitude, turn on
High Altitude Mode.
- If the problem persists, unplug the projector and
contact Epson for help.
|
Obstacle detection warning. A beep sounds and a warning
message is displayed. The brightness of the light source is
reduced.
- Make sure that there are no obstacles interfering
with the projection window. Remove any obstacles.
- Clean the obstacle sensor if there are no obstacles
present.
- Make sure the environmental temperature around the
air intake vents is not too hot.
The projector turns off automatically if no action is
taken. |
Movement detection warning. A beep sounds and a warning
message is displayed. The brightness of the light source is
reduced.
- Make sure that no one is looking into the projection
window. Move away from the projection window.
- Clean the motion sensor if there is no one near the
projection window
|
| Laser warning. Turn the projector off, unplug it, and
contact Epson for help. |
| Flashing orange |
Laser has a problem. Turn the projector off, unplug it,
and contact Epson for help. |
| A fan or sensor has a problem. Turn the projector off,
unplug it, and contact Epson for help. |
| Obstacle detection error. If there are no obstacles
interfering with the projection window, turn the projector off,
unplug it, and contact Epson for help. |
| Internal projector error. Turn the projector off,
unplug it, and contact Epson for help. |
