- Flip the feeder guard forward, then raise the paper support.
- Slide the edge guides out all the way.
- Pull out the output tray and open the paper stopper.
- If you
are inserting a stack of paper, fan the sheets first and tap the
stack on a flat surface to even the edges.
Note: Do not fan or curl photo paper.
- Do one
of the following:
- Insert paper, glossy or printable side up and short edge first, in the center of the paper support.
- Load up to 10 envelopes in the center of the paper support. Load them printable side up and flap edge left.
- Load a sheet of loose-leaf or other paper with holes facing as shown.
- To load a sheet of paper longer than legal size, close the paper support and flatten the leading edge of the paper as shown.
- Slide the edge guides against the paper, but not too tightly. Then flip the feeder guard back.
Always follow
these paper loading guidelines:
- Load only the recommended number of sheets.
- Load paper short edge first, no matter which way your document faces.
- Load letterhead or pre-printed paper top edge first.
- Do not load paper above the arrow mark inside the edge guide.
- If you have trouble loading a stack of envelopes, press each envelope flat before loading it or load one envelope at a time.
- Do not load envelopes that are curled, folded, or too thin, or that have plastic windows or exposed adhesive flaps.
- Check the paper package for any additional loading instructions.
- Do not place objects on the feeder guard. Doing so may prevent paper from feeding.
- Do not leave paper in the printer as the paper may curl or the print quality may decline.
- If you use paper with binder holes, load only one sheet at a time in only these sizes: Letter (8.5 × 11 inches [216 × 279 mm]), A4 (8.3 × 11.7 inches [210 × 297 mm]), or Legal (8.5 × 14 inches [216 × 356 mm]).