The power light is
flashing |
The product is busy. Wait for the power light to stop
flashing before turning off the product. |
The ink light is on |
Initial ink charging may not be complete. See the
Start Here sheet for instructions. |
The paper light is on |
No paper is loaded or multiple sheets fed at one time.
Load paper in the product, and press the B&W copy button or
the color copy button to
clear the error. |
The paper light is
flashing |
Paper is jammed in the product. Remove the jammed
paper, and press the B&W copy button or
the color copy button to
clear the error. |
The ink and paper lights are
flashing simultaneously |
An ink pad is nearing or at the end of its service
life. Contact Epson for support. If a message to continue printing
appears on your computer, press the B&W copy button or
the color copy button to
continue printing. |
The ink and paper lights are
flashing alternately |
A borderless printing ink pad is nearing or at the end
of its service life. Contact Epson for support. If a message to
continue printing appears on your computer, press the B&W copy button or
the color copy button to
continue printing. Borderless printing is not available until the
ink pad is replaced. |
All lights are flashing |
A printer error has occurred. Paper or protective
material is stuck inside the product. Open the front cover and
remove any jammed paper or protective materials. Turn the product
off and then back on again. If the error continues, contact Epson
for support. |
The Wi-Fi and Wi-Fi Direct lights are
flashing |
A Wi-Fi connection error has occurred. Press the
Wi-Fi
button to clear the error and try again. |
The ink light is on
The paper light is on
The Wi-Fi and Wi-Fi Direct lights are
on |
An error has occurred during firmware updating. Connect
your product using a USB cable and try updating the firmware again.
If the error continues, contact Epson for support. |
The ink light is on
The paper light is
on |
The product was not turned off correctly. Press the
B&W copy button or
the color copy button to
clear the error, then run a nozzle check and cancel any pending
print jobs. Always use the power button to turn off
the product. |