You can select the following settings for controlling the projector over a network.
| Setting | Options | Description |
|---|---|---|
| PJLink | On
Off |
Set to On to enable the PJLink notification function |
| PJLink Password | Up 32 alphanumeric characters | Enter a password for using the PJLink protocol for
projector control
(do not use spaces or any symbols besides @) |
| Notified IP Address | Various IP addresses | Enter the IP address to receive the projector's
operating status when the PJLink notification function is enabled.
Enter the addresses using 0 to 255 for each address field.
Do not use these addresses: 127.x.x.x or 224.0.0.0 through 255.255.255.255 (where x is a number from 0 to 255). |
| AMX Device Discovery | On
Off |
Set to On to allow AMX Device Discovery to detect the projector |
| Control4 SDDP | On
Off |
Set to On to allow device information to be acquired using Control4 Simple Device Discovery Protocol (SDDP) |