Setting the Remote Control ID

The remote control's ID is set to zero by default so it can operate any compatible projector. If you want to set the remote control to operate only a particular projector, you need to set the remote control's ID to match the projector's ID.
  1. Turn on the projector you want the remote control to operate with exclusively.
  2. Aim the remote control at that projector and press the ID button on the remote control. The current projector ID is displayed on the screen for about 3 seconds.
  3. Hold down the ID button on the remote control while you press the numeric button that matches the projector's ID. Then release the buttons.


    Note: If you select 0/All on the remote control, you can operate all projectors regardless of the Projector ID setting.
The remote control's ID is set.
Note: If the batteries are left out of the remote control for an extended period, the remote control ID returns to its default setting. If you use multiple remote controls at the same time, you may not be able to operate the projectors as intended due to infrared interference.
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use