If you have problems with automatic adjustments not
being applied correctly, try the following solutions:
- Wait 20
minutes after turning on the projector before performing the
automatic adjustments. This allows the projector temperature to
stabilize.
- Make sure there is no dirt or obstacles around the
optional external camera.
- Make sure the cable for the optional external camera
is securely connected to the projector.
- The optional external camera may be defective.
Contact Epson for help.
- If projecting from a analog input source, the
changing color and brightness of the image may cause automatic
adjustments to not be applied correctly.
- Make sure that a powerful spotlight or source of
strong natural light is not shining into the projection environment
and interfering with automatic adjustments.
- Check that your image correction and image blending
settings are within reasonable ranges. If the projection angle is
very large, try turning off the Geometry
Correction setting or reduce the projection angle. If you
are using the Edge Blending
setting, make sure the blending width is between 15 to 43%.
- If you see an error message during automatic
adjustments, check the error codes in the message.
During Screen Matching:
- 0101: Measurement value error
- 0102: Measurement failure
- 0103: Switch camera failure
- 0104/0105: Model mismatch
- 0108: Camera error
During Color Matching:
- 0201: Measurement value error
- 0202: Measurement failure
- 0203: Switch camera failure
- 0208: Camera error
Contact Epson support for details.