Network
administrators can install SNMP (Simple Network Management
Protocol) software on network computers so they can monitor
projectors. If your network uses this software, you can set up the
projector for SNMP monitoring.
- Press the Menu button.
- Select Network >
Network Settings >
Projector Control >
SNMP > On.
Note: If the Remote Password and the Web Control Password have not been set, a screen appears prompting you to set them. Enter passwords up to 32 characters long. These passwords are used for accessing the projector over a network, and you do not need to enter them to access the Network Settings menu after you set them.
- If no SNMP Community Name has been set, a screen appears prompting you to set one. Enter the SNMP Community Name (up to 32 alphanumeric characters).
- Enter up to two IP addresses to receive SNMP notifications
as the Trap IP Address
1 and Trap IP Address 2
settings, using 0 to 255 for each address field.
Note: To enter the IP address using the numeric keys on the remote control, press and hold the Num button. Do not use these addresses: 224.0.0.0 through 255.255.255.255. This projector supports SNMP agent version 1 (SNMPv1).
- When you finish selecting settings, select Return and press
Enter to return to the Network Settings menu. - Select Set, and follow the on-screen instructions to save your settings and exit the menus.