Performing Post-processing for Film

After you print your design on a sheet of film, remove it from the printer and perform post-processing to transfer it to your desired media.
Note: The steps for post-processing can vary depending on the type of film and powder you are using, the media you are transferring the design to, the specific equipment you are using to fix the ink, and even the amount of ink used. Make sure you check the instructions provided with the film and powder you are using, and consult your dealer and supplier for more information.
  1. Remove the printed film from the platen.
    Note: If you did not select Film as the job creation mode in Garment Creator 2, excess ink may run on the film sheet. Check that you selected Film as the job creation mode to avoid using excess ink.


  2. Once the film has been removed, perform post-processing to transfer it to your media.
    Caution:
    Do not apply powder near the printer.
Parent topic: Basic Printing