If you have problems with automatic adjustments not
being applied correctly, try the following solutions:
- Be sure to wait at least 20
minutes after turning on the projector or turning off the
Shutter setting before performing
automatic adjustments. This gives the projector's temperature a
chance to stabilize.
- Check that the camera area is clean.
- Make sure the cable of the optional camera is
securely connected to the projector.
- If you think the optional camera is defective,
contact Epson for help.
- Depending on the lens you installed, automatic
adjustments may not be available. Automatic adjustment is not
available for the following lenses: ELPLL08.
- If you are projecting from an analog input source,
the changing color and brightness of the image may cause automatic
adjustments to not be applied correctly.
- Make sure that a powerful spotlight or source of
strong natural light is not shining into the projection environment
and interfering with automatic adjustments.
- Check that your image correction and image blending
settings are within reasonable ranges. If the projection angle is
very large, try turning off the Geometry
Correction setting or reduce the projection angle. If you
are using the Edge Blending
setting, make sure the blending width is between 15 to 43%.
- If you see an error message during automatic
adjustments, make a note of the error codes and contact Epson for
support.
During Screen Matching:
- 0101: Measurement value error
- 0102: Measurement failure
- 0103: Switch camera failure
- 0104/0105: Model mismatch
- 0108: Camera error
During Color Matching:
- 0201: Measurement value error
- 0202: Measurement failure
- 0203: Switch camera failure
- 0208: Camera error