You
can create a horizontally wide screen image projected from two
projectors using the optional external camera. This function is
only available when the optional external camera is
installed.
Connect two projectors
using a LAN cable.
Turn on the
projectors.
Make sure the DHCP setting is turned on in the Network menu
on both projectors.
Note: Wait for one minute after assigning an IP
address automatically.
Select Extended > Multi-Projection > Simple Blending, and press Enter. Then press Enter again if necessary.
Select the Location
Setup setting and specify the primary projector from
A1 or B1.
Select the image aspect in the Whole Screen Aspect setting for the merged
wide image.
Note: You can set the following aspects using
the Whole Screen Aspect menu.
Selectable items vary depending on the screen type setting.
21:9 (EDID 3440x1440)
21:9 (EDID 2560x1080)
16:6 (EDID 2880x1080)
16:6 (EDID 1920x720)
3:1 (EDID 3240x1080)
32:10 (EDID 3456x1080)
32:9 (EDID 3200x900)
Perform Start Auto Adjustment. Follow the
on-screen instructions to adjust the projection position. If the
projection position cannot be adjusted fully using the Lens Shift button on the remote control or
the Lens button on the control
panel, move the projectors so that the green pattern and the
magenta pattern overlap and turn white.
After auto adjustment is complete, perform
Correct Shape following the
instructions on the screen.
Perform Screen Matching to adjust the brightness and
tint of the images.