IPv6 Settings

You can select IPv6 settings when you connect the projector to the network using IPv6.

IPv6

Set to On to connect the projector to the network using IPv6.

One local link address is always set while using IPv6. This is composed of the interface ID created from fe80:: and the projector's MAC address.

IPv6 is supported to monitor and control the projector over a network using Epson Web Control and PJLink.

Auto Configuration

Set to On to assign addresses automatically according to the Router Advertisement.

The address is composed as shown below.

Stateless Address (0 to 6): Created automatically by combining the prefix acquired from the RA (Router Advertisement) and the interface ID created from the projector's MAC address.
Stateful Address (0 to 1): Created automatically from the DHCP server using DHCPv6

Use Temporary Address

Set to On if you want to use a temporary IPv6 address.

Note: You can set the IPv6 address manually in the Advanced menu in Epson Web Control.