To set up
your projector for monitoring and control using a Crestron
Connected system, make sure your computer and projector are
connected to the network.
Note: If you
want to use the Crestron Connected system when the projector is
turned off, you need to adjust the Standby Mode settings in the Extended
menu.
- Press the Menu button.
- Select the Network menu
and press
Enter. - Select the Others menu
and press Enter.
- Set the Crestron
Connected setting to On to
allow the projector to be detected.
Note: Enabling Crestron Connected disables the Message Broadcasting feature in the Epson Projector Management software. To enable the Crestron XiO Cloud service, set Crestron XiO Cloud to On.
- When you are finished selecting settings, select Complete and follow the on-screen instructions to save your settings and exit the menus.
- Turn off the projector, then turn it on again to enable the setting.
- Start your Web browser on a computer or device connected to the network.
- Go to the Epson Web Control screen by entering the projector's IP address into the browser's address box.
- Select the Crestron Connected settings. See the Crestron Web site for details.
