Connecting an Authentication Device

You can connect an authentication device such as an IC card reader using a USB cable, and check the functionality of the reader using the Web Config interface.
  1. Remove the sticker covering the service port on the rear of the product.


  2. Connect the card reader’s USB cable to the service port on the product.
    Caution:
    Make sure the cable does not block the rear cover.


  3. Access Web Config and log in using the administrator name and password.
    Note: You can also check the card reader status on the product control panel by selecting Settings > Authentication Device Status.
  4. Select Device Management > Card Reader.
  5. Set the card reader parameters as necessary.
  6. Select Check to verify the connection status of the authentication device.
    Note: To confirm that the authentication device can recognize an authentication card, hold the card over the reader while you select Check.
  7. Click Next.
  8. Click OK to confirm the settings.
Parent topic: Configuring Security Settings
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use