Using WPS to Connect to a Network

If you have a WPS-enabled wireless router or access point, you can use Wi-Fi Protected Setup (WPS) to connect your product to the network.
Note: This setting can be locked by an administrator. If you cannot access or change this setting, contact your administrator for assistance.
  1. Press the  home button, if necessary.
  2. Select the network icon.
    Note: Icon may look different depending on connection status.
  3. Select Router > Start Setup or Change Settings > Push Button Setup (WPS).
  4. Hold down the WPS button on your wireless router until the security light flashes.
  5. Select Start Setup on the LCD screen within two minutes of activating WPS on your router.
    If connection was successful, a confirmation message appears. Select Close or wait for the message to time out. If connection was unsuccessful, an error message appears. Select OK or Close and repeat these steps to try again.
  6. Press the  home button to exit.
    You see the Wi-Fi icon on the LCD screen and should be able to connect to your product directly from your computer or device, and then print. If you are printing from a computer, make sure you installed the product software from the Epson website.
    Note: If you don't see the Wi-Fi icon, restart the access point, move it closer to the printer, and repeat these steps to try again. If it still does not work, print a network connection report and check the solution.
Parent topic: Wi-Fi Protected Setup (WPS)