If
the projected image is fuzzy or blurry, try the following steps
until the problem is solved.
Note: Focus and keystone distortion of the
projected image are automatically corrected under the following
conditions:
- When the size of the projected image (diagonal length) before
correcting focus and keystone distortion is from 30 to 100
inches.
- When the projection distance is about 28 to 87 inches (0.7 to
2.2 m).
- When the installation angle of the projector toward the
projection surface is within 20ยบ right, left, up, or down.
-
Hold down the
focus button on the remote
control to perform Auto
Focus.
- Press the focus button on the remote
control to display the focus adjustment screen and adjust focus
manually.
- Check the following items:
- Position the projector close enough to the screen.
- Position the projector so the keystone adjustment angle is not
so wide that it distorts the image.
- Clean the projector's lens.
Note: To avoid condensation on the lens after
bringing the projector in from a cold environment, let the
projector warm up to room temperature before using it.
- Adjust the Sharpness setting in the projector's
Display & Sound menu to improve
image quality.
- Display & Sound >
Picture > Custom > Sharpness
- If you are projecting from a computer,
use a lower resolution or select a resolution that matches the
projector's native resolution.
Note: If you cannot correct the focus and any
distortion of the projected image, turn off the projector and
disconnect the power cord, then reconnect the power cord and turn
the projector back on. If a warning screen is displayed when you
turn on the projector, contact Epson for help.