Synchronizing the Date and Time with a Time Server
You can synchronize the product with an NTP time server to set the date and time on the product.
Note:
If you are using a CA certificate or Kerberos authentication, it is recommended to use a time server to set the date and time.
Log in to the Web Config interface as an administrator.
Select the
Device Management
tab, then select the
Date and Time
>
Time Server
setting.
Set
Use Time Server
to
Use
.
Enter the time server address in
Time Server Address
. You can use the IPv4, IPv6, or FQDN format for the address. You are limited to 252 characters.
Note:
If you do not specify the address, leave it blank.
Enter an update interval (up to 10080 minutes) in
Update Interval (min)
.
Click
OK
to update the settings.
Note:
You can see the time server connection status next to
Time Server Status
.
Parent topic:
Configuring Product Settings
Was this page helpful?
Yes
or
No
.
Privacy Policy
|
Your California Privacy Rights
|
Terms of Use