If
you cannot install the projector directly in front of the screen,
you can adjust the position of the projected image using the lens
shift feature.
Caution: When shifting the lens, do not put your
hands near the lens unit. Your fingers may get caught between the
lens unit and the projector, and cause an injury.
Note: Wait
20 minutes after turning on the projector
before setting the focus, zoom, and lens shift for maximum
accuracy.
- Turn on the projector and display an image.
-
Press the arrow buttons on
the remote control or the control panel to adjust the position of
the projected image as necessary.
The distance the image can be shifted varies depending on the installed lens. The limits are described in the following table. You can shift the image up to the listed percentage of the image height or width. - When you are finished, press the Esc button on the control panel or remote control.
Note: When
adjusting the image height, position the image lower than where you
want it to be and then move it up. This will help prevent the image
from moving down after adjustment. The image is
clearest when the lens is in the home position. To move the lens to
the home position, press and hold the Lens Shift button on the remote control or
the Lens button on the control
panel for at least three seconds.