Using WPS PIN Mode to Connect to a Network

If you have a WPS-enabled wireless router or access point that supports PIN mode, you can use Wi-Fi Protected Setup (WPS) PIN mode to connect your scanner to the network.
  1. Open the input tray.
  2. Press and hold the  Wi-Fi on/off button and the  Wi-Fi connect button on the scanner simultaneously for at least three seconds, then release them when the  Wi-Fi on/off light flashes blue.
  3. Enter the PIN code 01234565 on the wireless router or access point within two minutes. The  Wi-Fi on/off and  AP mode lights flash alternately while establishing the connection. When the  Wi-Fi on/off light on the scanner stays on, the scanner is connected to the network.
    Note: If the ! error light turns on, the connection failed. Press the  stop button to clear the error, restart the access point, and repeat these steps.
Related tasks
Setting Up Network Scanning