Network
administrators can install SNMP (Simple Network Management
Protocol) software on network computers so they can monitor
projectors. If your network uses this software, you can set up the
projector for SNMP monitoring.
Press
the Menu button.
Select
the Network menu and press
Enter.
Select
Network Configuration and press
Enter.
Select
the Others menu and press
Enter.
Enter up
to two IP addresses to receive SNMP notifications, using 0 to 255
for each address field.
Note: Do not use
these addresses: 127.x.x.x or 224.0.0.0 through 255.255.255.255
(where x is a number from 0 to 255).
If
available, select the Priority
Gateway setting for your network.
If your
network environment uses an AMX controller, turn on the
AMX Device Discovery setting to
allow the projector to be detected.
If your
network environment uses a Crestron RoomView controller, turn on
the Crestron RoomView setting to
allow the projector to be detected.
If you
are connecting to a network using Bonjour, turn on the Bonjour setting.
When you
finish selecting settings, select Complete and follow the on-screen instructions
to save your settings and exit the menus.
