User's Guide

Index	Help	Safety

Contents

Problem Solver

General Problems

Cannot configure the network interface or cannot print from the network.
Cause	What to do
The printer settings or network settings may be wrong.	First, check to see if you can print a status sheet, as described in Status sheet button. If you can print a status sheet, check the network settings; otherwise, set the interface mode of the printer's control panel to Auto or Option.
Cannot print even if you have assigned the IP address to the computer and the network interface.
Cause	What to do
You have assigned an IP address to the computer manually, but you assigned the IP address to the network interface by Automatic Private IP Addressing (APIPA).	Assign the IP address for the network interface so that it belongs to the same segment of the computer. Use EpsonNet Config or the printer's control panel.
Unable to start EpsonNet Config.
Cause	What to do
You have added or deleted protocols after installing EpsonNet Config.	Uninstall EpsonNet Config and then reinstall it. See Uninstalling Software and Installing EpsonNet Config for Windows.
The message "Could not install the printer driver." appears when you set up the network interface.
Cause	What to do
You have not installed the printer driver.	Install the printer driver on your computer before setting up the network interface. See About Installing the Printer Driver or the manual shipped with your printer for instructions on how to install the printer driver.
The message "EpsonNet Config cannot be used because no network is installed." appears when you start EpsonNet Config.
Cause	What to do
Both TCP/IP and IPX/SPX are not installed on the computer.	Install the TCP/IP or IPX/SPX protocol.
TCP/IP is installed on the computer, but its IP address is not set correctly.	Set a correct IP address for the computer.
The message "Could not complete communicating configuration data" appears when you send settings to the network interface.
Cause	What to do
This may happen when using a dial-up router.	Run Command Prompt from the computer on which EpsonNet Config is installed, and then enter the following command: Format: >ROUTE_ADD_the IP address of the network interface_ the IP address of the computer (the under bar represents one space) Example: >ROUTE ADD 192.168.192.168 22.33.44.55.
Unable to start EpsonNet Config with Web Browser.
Cause	What to do
You have not set the IP address for the network interface.	Set the IP address for the network interface using EpsonNet Config for Windows or Macintosh, the printer's control panel, or the arp/ping commands. You can check the IP address on a status sheet. See the EpsonNet Config User's Guide or Setting an IP Address Using the arp/ping Command.
Unable to set the IP address using the arp/ping commands.
Cause	What to do
The network interface is not connected to the network.	Connect the network interface to the network, and check the network environment.
The device is located beyond the router.	The device and the computer must be in the same segment.
The Model Name and IP Address do not appear in the EpsonNet Config dialog box.
Cause	What to do
If the valid IP address is not set, the items indicated in the dialog box mentioned above may not appear.	Set a valid IP address. Refresh the status by selecting Refresh from the View menu. Increase the length of time before a timeout. To do this, select Options from the Tool menu, and then select Timeout. Note that doing so can cause EpsonNet Config to run more slowly.
An extra account is generated when using the dial-up network.
Cause	What to do
NetWare is set to Enable even though you are not using NetWare.	Set NetWare to Disable on the NetWare screen of EpsonNet Config with Web Browser.
The network interface does not appear in the EpsonNet Config list view.
Cause	What to do
There are several possible causes. Check the items described on the right.	Make sure the printer is turned on.
How to acquire an IP address. To acquire your IP address, you need to apply to the NIC (Network Information Center) in your country.

[Top]