Creating Public Access Printers
Configuring an LPR Printer in NetWare Administrator
Follow the steps below to configure an LPR printer in NetWare Administrator.
NOTE:
If you have not finished the previous procedures yet, go back to "Creating Public Access Printers in NetWare Administrator".
- Select Remote (LPR on IP) in the NDPS Gateway Configuration dialog box. The following dialog appears.
- Type the IP address of the print server.
NOTE:
- Do not enter values larger than 233 in the first box.
- Since the EpsonNet NDPS Gateway does not verify whether the IP address is valid or not, make sure to enter the correct IP address.
- Press Finish, and follow the on-screen instructions.
- The Select Printer Drivers dialog appears.
- Select appropriate printer driver for Windows 95/98 and Windows NT 4.0; and select [None] for Windows 3.1. Be sure to select the printer driver corresponding to your specific printer under both the Windows 95/98 and Windows NT 4.0 menus.
See "Installing Printers on Workstations" for printers supported by the EpsonNet NDPS Gateway.
- Click Continue.
The new Printer Agent will appear in the Printer Agent List window.
|
NOTE:
|
- If you have not yet assigned the IP address, configure the print server using the appropriate configuration utility shipped with the print server. After configuring the print server, be sure to turn the printer off and back on to reset the printer.
- The message "The Printer Agent just created needs attention. Check Printer details or the server console for more information." might appear after creating Printer Agents. This message appears while the EpsonNet NDPS Gateway creates the Printer Agent. Click OK to close this message box and wait a while.
|