Make sure
you have your replacement cartridges handy before you begin. You
must install new cartridges immediately after removing the old
ones.
Caution:
Leave your old cartridges in the printer until
you are ready to replace them to prevent the print head nozzles
from drying out. Do not open ink cartridge packages until you are
ready to install the ink. Cartridges are vacuum packed to maintain
reliability.
- Turn on
your product.
- If an ink
cartridge is expended, you see a message on the LCD screen. Note
which cartridges need to be replaced and press the
OK button, then choose
Replace now.
- If you are
replacing a cartridge before you see a message on the LCD screen,
press the home button if necessary and
select Setup. Select Maintenance, then select Ink Cartridge Replacement and press the
OK button.
- Lift up
the scanner unit.
Caution:
Do not move the print head by hand; otherwise,
you may damage your product. Do not touch the flat white cable
inside the printer.
- Squeeze
the tab on the cartridge and lift the cartridge straight up to
remove it.
Note: Dispose of
used cartridges carefully. Do not take the used cartridge apart or
try to refill it.
Warning: If ink
gets on your skin, wash it thoroughly with soap and water. If ink
gets into your eyes, flush them immediately with water. If ink gets
into your mouth, spit it out and see a doctor right away. Keep ink
cartridges out of the reach of children.
- Before
opening the new cartridge package, shake it gently four or five
times.
Caution:
Do not shake the cartridges after opening the
packages, or ink may leak.
- Remove
the cartridge from the package.
Caution:
Do not touch the green chip on the cartridge.
Install the new cartridge immediately after removing the old one;
if you do not, the print head may dry out and be unable to
print.
- Remove
the yellow tape from the bottom of the cartridge.
Caution:
Do not remove any other labels or seals, or
ink will leak.
- Insert
the new cartridge into the holder and push it down until it clicks
into place.
- Press
the OK
button.
- Lower
the scanner unit.
The print head moves to its home position and the printer starts
charging the ink. This takes about 2 minutes. When you see a
confirmation message on the screen, ink charging is finished.
Caution:
Never turn off the product while the power
light is flashing or you will waste ink.
If you see an error screen telling you an ink cartridge is
installed incorrectly, lift up the scanner unit and press the ink
cartridge down until it clicks into place. When you're finished,
press the OK
button.
If you remove a low or expended ink cartridge, you cannot
re-install and use the cartridge.
Caution:
If you remove an ink cartridge for later use,
protect the ink supply area from dirt and dust and store it in the
same environment as the printer. The valve in the ink supply port
is designed to contain any excess ink, but do not touch the ink
supply port or surrounding area. Always store ink cartridges with
the label facing up; do not store cartridges upside-down.