|
|
How To / Using Automatic Roll Paper Cutter
Remove the cutter as the following steps.
![]() | Caution: |
![]() | Be sure to turn the printer off for safety reasons when removing the cutter from the printer. |
Holding down the buttons on both ends of the cutter, pull the cutter toward you and remove it.
To attach the output tray again, follow the instructions below.
![]() | Join the hole that is on the right of the output tray and the prong that is on the right of the sheet feeder. |
![]() | Press the lever that is on the left side of the output tray to the right. |
![]() | Leaning the output tray, then insert the prong that is on the left of the output tray into the slot on the left of the sheet feeder. |
![]() Previous |
![]() Next |
Version 1.00E, Copyright © 2001, SEIKO EPSON CORPORATION |