|
Setting an IP Address on the Printer’s Control Panel
Network Setup Menu
After connecting the printer to the network, you need to set the IP address for the network interface.
To set the IP address, subnet mask, and default gateway from the control panel, follow the steps below.
Configure the network interface for use on a TCP/IP network.
|
Make sure the printer is turned on, and the LCD displays READY.
|
|
Press Menu button on the printer to enter the printer’s menu system.
|
|
Press Enter, an asterisk appears next to ENABLE to show that it’s selected.
|
|
Press Enter. An asterisk appears next to the setting you selected.
|
|
Press to go back. Then do one of the following:
|
|
Turn the printer off then back on again.
|
Print a network status sheet to confirm the new IP address. See .
|
Note: |
These items are used to make network settings on the printer’s control panel.
Item
|
Settings (default in bold)
|
NETWORK SETUP
|
Disable, Enable
|
IP ADDRESS SETTING*
|
Auto, Panel, PING
|
IP*
|
0.0.0.0 to 255.255.255.255
|
SM*
|
0.0.0.0 to 255.255.255.255
|
GW*
|
0.0.0.0 to 255.255.255.255
|
AppleTalk*
|
On, Off
|
MS Network*
|
On, Off
|
Bonjour*
|
On, Off
|
INIT NETWORK SETTING*
|
EXECUTE
|
* Available only when Enable is selected for NETWORK SETUP.
| |