Reference Guide

Index Search Glossary Contents Help

Printing / Basic Printing Information

Loading Single Sheets of Paper

This section provides instructions on how to load paper in the sheet feeder.

Note:

Leave enough space in front of the Stylus Photo RX600 for paper to be fully ejected.

Open the output tray.

Move the feeder guard towards you.

While holding down its locking tab, slide out the left edge guide.

Fan a stack of paper, and then tap it on a flat surface to even the edges.

Load the stack of paper with the printable side facing down and resting against the guide of the feeder guard.

Stand the stack of paper against the paper support and slide the left edge guide so that it meets the left edge of the paper.

Note:

Always load paper into the sheet feeder's short edge first.

Make sure that the paper stack is flush with or lower than the triangular mark on the edge guide.

Make sure that the paper is loaded under the tabs inside the edge guides.

Set the feeder guard back.

Note:

If the paper is curled, flatten it or bend it slightly in the opposite direction before loading. Printing on curled paper may cause ink to smear on printouts.

[Top]