If you cannot print over a network, try these
solutions:
- Make sure
that your product is turned on.
- Make sure
you install your product's network software as described in your
product documentation.
- Print a
network status sheet and verify that the network settings are
correct. If the network status is Disconnected, check any cable connections and
turn your product off and then on again.
- If you are
using TCP/IP, make sure the product's IP address is set correctly
for your network. If your network does not assign IP addresses
using DHCP, set the IP address manually.
- If network
printing is slow, print a network status sheet and check the signal
strength. If it is poor, place your product closer to your router
or access point.
Note: Avoid
placing your product near a microwave oven, 2.4 GHz cordless phone,
or large metal object, such as a filing cabinet.
- Check your
wired LAN router or access point to see if the LED for the port to
which your product is connected is on or flashing . If the link LED
is off, try the following:
- Make sure
the Ethernet cable is securely connected to your product and to
your router, access point, switch, or hub.
- Try
connecting your product to a different port or a different router,
access point, switch, or hub.
- Try
connecting with a different Ethernet cable.
- Try printing
to your product from another computer on the network.
- If you are
connecting the product via EpsonNet Setup and the WiFi light on your product is not solid green , make
sure your product software was installed correctly. If necessary,
reinstall your software.