Running a Product Check

Running a product check helps you determine if your product is operating properly.
  1. Disconnect any interface cables connected to your product.
  2. Load a few sheets of plain paper in the product.
  3. Press the  Menu button.
  4. Press the up or down arrow buttons to select Maintenance and press the OK button. You see this screen:


  5. Press the up or down arrow buttons to select Nozzle Check and press the OK button.
  6. Press one of the  Start buttons. After the nozzle pattern prints, you see this screen:


  7. Do the following, depending on the results of the product check:
    • If the page prints and the nozzle check pattern is complete, the product is operating properly. Any operation problem you may have could be caused by your computer, cable, software, or selected settings. Check the other solutions in this book or try uninstalling and reinstalling your printer software.
    • If the page prints but the nozzle check pattern has gaps, clean or align the print head.
    • If the page does not print, the product may have a problem. Check the other solutions in this manual. If they do not work, contact Epson.
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use