If you cannot print over a network, try these solutions:
- Make sure
that your product is turned on.
- Make sure
you install your product's network software as described in your
product documentation.
- Print a
network status sheet and verify that the network settings are
correct. If the network status is Disconnected, check any cable connections and
turn your product off and then on again.
- If you are
using TCP/IP, make sure the product's IP address is set correctly
for your network. If your network does not assign IP addresses
using DHCP, set the IP address manually.
- Make sure
your computer and product are both using the same wireless
network.
- Check your
wired LAN router or access point to see if the LED for the port to
which your product is connected is on or flashing. If the link LED
is off, try the following:
- Make sure
the Ethernet cable is securely connected to your product and to
your router, access point, switch, or hub.
- Try
connecting your product to a different port or a different router,
access point, switch, or hub.
- Try
connecting with a different Ethernet cable.
- Try printing
to your product from another computer on the network.
- If you are
connecting the product via EpsonNet Setup and the WiFi
light on your product is not solid green, make sure your product
software was installed correctly. If necessary, reinstall your
software.