You can
enable Wi-Fi Direct mode to allow direct communication between your
product and computer or other devices without a wireless router or
access point.
Press the home button, if
necessary.
Press the arrow buttons to select Wi-Fi Setup and press the OK button. You
see this screen:
Press the arrow buttons to select Wi-Fi Direct Setup and press the OK
button.
Press the down arrow button, then press the OK button to change
the Wi-Fi Direct password.
Note: If you
have already connected devices or computers to your product via
Wi-Fi Direct, they will be disconnected when you change the
password.
Enter your Wi-Fi Direct password.
Note: Your
password must be at least 8 and no more than 22 characters
long.
Press the up
and down arrow buttons to scroll through characters. Then press the
right arrow button to move to the next character.
To switch
between ABC (uppercase),
abc (lowercase), or 123 (numbers and symbols), press the
home button.
To delete
characters, press the left arrow.
When you
finish entering characters, press the OK button.
Press the OK button. You see this screen:
Use your computer or wireless device to select the Wi-Fi
network name (SSID) displayed on the LCD screen, then enter the
password shown.
Press the OK button to exit. You see
either an AP or D connection symbol on the LCD screen and
should be able to print directly to your product from your computer
or device.
Note: If the
AP or D connection symbol is not displayed on the
LCD screen, Wi-Fi Direct mode is not enabled. Repeat these steps to
try again.