Using WPS PIN Mode to Connect to a Network

If you have a WPS-enabled wireless router or access point that supports PIN mode, you can use Wi-Fi Protected Setup (WPS) PIN mode to connect your scanner to the network.
  1. Set the connection mode switch on the scanner to AP mode.


  2. Open the input tray.
  3. Press and hold the Connect button and press the  power button to turn on the scanner.


  4. Hold the Connect button until the Status and ! error lights flash alternately. The scanner enters standby mode for WPS connection for two minutes.
  5. Enter the PIN code 01234565 on the wireless router or access point within two minutes. The Status light on the scanner stays on, indicating that the scanner is connected to the network.
  6. Turn off the scanner.
  7. Set the connection mode switch on the scanner to Wi-Fi.


  8. Turn on the scanner. The Status light on the scanner stays on, indicating that the scanner is connected to the network.
  9. Set up network scanning on your computer.
Parent topic: Wi-Fi Protected Setup (WPS)
Related tasks
Setting Up Network Scanning