The  power light is on |
The product is turned on. |
| The power light is flashing |
The product is busy. Wait for the
power light to stop flashing
before turning off the product.
If you just filled the ink, the power light will flash
for approximately 20 minutes. Do not cancel this process. |
| The power light is flashing
The  paper light is
flashing |
Paper is jammed in the product. Remove
the jammed paper, and press the  stop button to clear the
error. |
| The power light is flashing
The paper light is on |
No paper is loaded or multiple sheets fed at
one time. Load paper in the product, and press the
stop button to clear the
error. |
| The power light is on or flashing
The  ink light is
flashing |
Ink level may be low. It is nearly time to
reset the ink levels by refilling the ink. You can continue
printing, but you should prepare new ink bottles. To confirm the
actual ink remaining, visually check the ink levels in the
product's ink tanks. |
| The power light is on or flashing
The ink light is on |
Ink level may have reached the lower line of
the ink tank and it is time to reset the ink levels. To reset the
ink levels, refill the ink.
Caution:
Continued use of the product when the ink
level is below the lower line on the ink tank could damage the
product. |
| The power light is on or flashing
The ink light is flashing
The paper light is
flashing |
The ink pads are near the end of their service
life. Contact Epson for support. |
| The ink light is on
The paper light is on |
An error has occurred during firmware updating.
Connect your product using a USB cable and try updating the
firmware again. If the error message continues, contact Epson for
support. |
| The power light is flashing
The ink light is flashing
The paper light is
flashing |
A fatal error has occurred. Turn the product
off and then back on again. If the error continues, check for a
paper jam. If the error persists, contact Epson for support. |
