Your
projector came with a blue pen and an orange pen, identified by the
color on the end of the pen. You can use either pen, or both pens
at the same time (one of each color), with Easy Interactive Tools.
Make sure the pen batteries are installed.
Note: The pen
turns off automatically after 15 seconds of inactivity. Hold the
pen to turn the pen back on.
| 1 | Pen tip |
| 2 | Battery light |
| 3 | Function button |
| 4 | Attachment for optional strap or cord |
| 5 | Battery cover |
- To turn on the pen, move the pen.
Note: If you press the function button, the battery light flashes briefly, then turns off. If the battery is low, the battery light flashes continuously.
- For best performance, hold the pen perpendicular to the board, as shown below. Do not cover the black section near the tip of the pen.
- To write or draw on the projection surface in built-in
annotation mode or built-in whiteboard mode, do the
following:
- To select a projected item, such as an icon, tap the projection surface with the pen tip.
- To draw on the projected screen, tap the projection surface with the pen and drag it as necessary.
- To move the pointer, hover over the surface without touching it.
- To switch the
pen from drawing tool to eraser, press the button on the side.
Note: You can change the function of the button by changing the Pen Button Function setting in the Extended menu.
- To use the pen as a mouse in PC Interactive mode, do the
following:
- To left-click, tap the board with the pen tip.
- To double-click, tap twice.
- To right-click, press the button on the side.
- To click and drag, tap and drag with the pen.
- To move the
cursor, hover over the board without touching it.
Note: You can turn off the hovering feature using the Hovering setting in the projector's Easy Interactive Function menu.Note: To make a long press of the pen act as a right-click, set the Pen Operation Mode setting to Ubuntu Mode and turn on the Enable Right Click setting.
