Projector Information Display - Info Menu

You can display information about the projector and input sources by viewing the Info menu. However, you cannot change any settings in the menu.



Select Version to display the projector's firmware version. Select Projector Info to display the settings described below.

Note: Available settings depend on the current input source. The lamp usage timer does not register any hours until you have used the lamp for at least 10 hours.
Information item Description
Lamp Hours Displays the number of hours (H) the lamp has been used in Normal and ECO Power Consumption modes; if the information is displayed in yellow, obtain a genuine Epson replacement lamp soon
Source Displays the name of the port to which the current input source is connected
Input Signal Displays the input signal setting of the current input source
Resolution Displays the resolution of the current input source
Video Signal Displays the video signal format of the current input source
Refresh Rate Displays the refresh rate of the current input source
Sync Info Displays information that may be needed by a service technician
Status Displays information about projector problems that may be needed by a service technician
Serial Number Displays the projector's serial number
Event ID Displays the Event ID number corresponding to a specific projector problem; see the list of Event ID codes
HDBaseT Signal Level

(PowerLite 2165W/2265U )

Displays the signal level of the HDBaseT transmitter; a yellow signal level indicates the signal is weak
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use