Solutions When Only a Partial Image Appears

If only a partial computer image appears, try the following solutions:
  • Press the Auto button on the remote control to optimize the image signal.
  • For VGA connections, press the Auto button on the remote control to optimize the image signal.
  • Make sure the Resolution setting in the Signal menu is set correctly to for the input signal.
  • Try adjusting the image position using the Position menu setting.
  • Press the Aspect button on the remote control to select a different image aspect ratio.
  • If you zoomed into or out of the image using the E-Zoom buttons, press the Esc button until the projector returns to a full display.
  • Check the cables connecting the computer or video source to the projector. Try connecting different cables.
  • Check your computer display settings to disable dual display and set the resolution within the projector's limits. (See your computer manual for details.)
  • Check the resolution assigned to your presentation files to see if they are created for a different resolution than you are projecting in. (See your software help for details.)
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use