Saving a Scheduled Event

You can select projector commands you want to perform and schedule them as an event.
You cannot schedule an event to occur at the following times:
  • Five minutes before or after a Color Calibration event
  • Five minutes before or 30 minutes after a Screen Matching event
Note: Make sure to perform Screen Matching after executing Light Source Calibration.
Note: When you have set Light Source Calibration or Screen Matching events and you want to apply this schedule to other projectors with tiling settings, set Sync Schedule to On.
  1. Press the Menu button.
  2. Select the Extended menu and press Enter.
  3. Select the Schedule Settings setting and press Enter. You see a screen like this:


  4. Select the Schedule or Extended Schedule menu and press Enter.
  5. Select Add New and press Enter.
  6. In the Event Settings section, select the events you want to have occur. (Select No Change or Off for events that you do not want to occur.)
    Note: In the Extended Schedule menu, you can schedule only one event for Color Calibration or Screen Matching.
  7. In the Date/Time Settings section, set the date and time for the scheduled events to occur.
  8. When you are finished, select Save and press Enter.
  9. To schedule more events, repeat the previous steps as necessary.
  10. Select Setup complete and select Yes to save your changes.
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use