Power Cleaning Using the Product Control Panel

You can run a Power Cleaning using the control panel on your product.
Note: After a Power Cleaning, you must turn off the product and wait at least 12 hours before running another Power Cleaning.
  1. Make sure there are no errors on the LCD screen.
  2. Turn off the product.
  3. Visually check the ink level and make sure the ink tank is at least one-third full.
    Caution:
    If you run a Power Cleaning when the ink level is low, you may damage the product.
  4. Press and hold the  power button and the  help button at the same time until you see the Power Cleaning screen. Then release both buttons.
  5. Follow the instructions on the LCD screen to run the Power Cleaning.
  6. When the Power Cleaning is finished, run a nozzle check.

If the print quality did not improve, turn off the product and wait at least 12 hours before running another Power Cleaning.

If the print quality does not improve after running the Power Cleaning utility multiple times, contact Epson for support.

Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use