You can
check the print head nozzles using the buttons on your
product.
Press
the power button to turn the
product off.
Load a
few sheets of plain paper in the product.
Hold
down the stop button and press the
power button to turn the
product on.
When the
product turns on, release both buttons. The product prints a
nozzle check pattern.
Note: It can take
a few seconds for the nozzle check pattern to start printing. If it
does not start printing after a few seconds, make sure there is
paper loaded in the product.
Check
the printed pattern to see if there are gaps in the lines.
Print head is clean
Print head needs cleaning
Print head needs Power Cleaning
Do one
of the following:
If there are no gaps, the print head is clean and you can
continue printing.
If there are gaps or the pattern is faint, clean the print
head. If almost the entire pattern is missing, see the link
below for instructions on performing a Power Cleaning.
If you don’t see any
improvement after cleaning the print head up to 3 times, turn off
the product and wait at least 12 hours. Then run a nozzle check and
try cleaning the print head again. If quality still does not
improve, run a Power Cleaning.
power
stop
