If only a partial computer image appears, try the
following solutions:
- For VGA connections, press the Auto button on the remote control to optimize
the image signal.
- Make sure you selected the correct Screen Type setting in the projector's
Installation menu for the screen you are using. If there are
margins between the edge of the image and the projected screen
frame, use the Screen Position
setting to adjust the position of the image.
- Make sure the Resolution setting
in the Image menu is set correctly for the input signal.
- Try adjusting the image position using the Position setting in the Image menu.
-
Press the
Aspect button on the remote control
to select a different image aspect ratio.
- If you zoomed into or out of the image using the E-Zoom buttons, press the Default button until the projector returns to a
full display.
-
Check your
computer display settings to disable dual display and set the
resolution within the projector's limits. (See your computer manual
for details.)
-
Check the
resolution assigned to your presentation files to see if they are
created for a different resolution than you are projecting in. (See
your software help for details.)
- Make sure you selected the correct Projection setting in the Installation
menu.