To set up
your projector for monitoring and control using a Crestron
Connected system, make sure your computer and projector are
connected to the network.
Note: You
cannot use the Message Broadcasting feature in Epson Projector
Management when you use Crestron Connected.
Note: If you
want to use the Crestron Connected system when the projector is
turned off, you need to adjust the Standby Mode setting in the Operation menu.
The Standby Mode setting is
displayed only if the A/V Output
setting in the Signal I/O menu is set to While Projecting.
- Press the Menu button.
- Select the Network menu
and press
Enter. - Select Network Settings and press Enter.
Note: If the Remote Password and the Web Control Password have not been set, a screen appears prompting you to set them. Enter passwords up to 32 characters long. These passwords are used for accessing the projector over a network, and you do not need to enter them to access the Network Settings menu after you set them.
- Select the Projector Control menu and press Enter.
- Set the Crestron
Connected setting to On to
allow the projector to be detected.
Note: Enabling Crestron Connected disables the Message Broadcasting feature in the Epson Projector Management software. To enable the Crestron XiO Cloud service, set Crestron XiO Cloud to On.
- When you are finished selecting settings, select
Return and press Enter to return to the Network Settings menu.
- Turn off the projector, then turn it on again to enable the setting.
- Start your Web browser on a computer or device connected to the network.
- Go to the Epson Web Control screen by entering the projector's IP address into the browser's address box.
- Select the Crestron Connected settings. See the Crestron Web site for details.
