Complies with FDA performance standards for laser
products except for conformance as a Risk Group 2 LIP as defined in
IEC 62471-5: Ed. 1.0. For more information see Laser Notice No. 57,
dated May 8, 2019.
This projector is a Class 1/RG2 laser product that
complies with the IEC60825-1:2014 international standard for laser
products and the IEC62471-5:2015 international standard for laser
illuminated projectors. This projector also complies with US
requirements for LIPs (Laser Illuminated Projectors) via the terms
of US FDA CDRH Classification and Requirements for Laser
Illuminated Projectors (LIPs) (Laser Notice No. 57) dated May 8,
2019.
This projector can only be installed or used by
qualified personnel with an approved laser light show variance.
Installers must have a valid variance for production of Class 3B
and Class 4 laser light shows and/or for incorporation of the RG3
LIPs into their shows. Dealers, distributors, and end-users are
also required to obtain a valid laser light show variance. If you
are renting out this projector in the US, it shall only be
delivered to parties that demonstrate they have a valid variance in
effect at the time of delivery that permits the production of laser
light shows incorporating either Class 3B/4, or RG3 LIP
projectors.
This projector contains a high-powered laser
component and the following precautions should be taken when
operating the projector to avoid injury or damage:
- This is a class A product. In a domestic environment
this product may cause radio interference in which case the user
may be required to take adequate measures.
- Do not open the projector's case. The projector
contains a high-powered laser.
- Possibly hazardous optical radiation emitted from
this product. Do not look at operating light source. Eye injury may
result.
- Do not expose the light from the projector to
optical devices, such as a magnifying glass or reflectors.
Continuing to use the projector in this condition could cause
viewers to feel unwell. It could also cause a fire or
accident.
- As with any bright source, do not stare into the
beam, RG2 IEC/EN 62471-5:2015.
- This projector may become RG3 when an
interchangeable lens with a throw ratio greater than 2.15 is
installed. Refer to the lens list and hazard distance before
operation. Such combinations of projector and lens are intended for
professional use only, and are not intended for consumer use.
- Operators shall control access to the beam within
the hazard distance or install the product at a height that will
prevent eye exposure within the hazard distance.
- No direct exposure to the beam shall be
permitted.
Caution:
Do not disassemble the projector when
disposing of it. Dispose according to your local or national laws
and regulations.
Note: See the
link below for additional safety laser cautions and other general
safety instructions.