 |
 |
|
 |
||
Setting and Placing Film
Note:|
Before scanning films, be sure to use a soft cloth to wipe the Transparency Unit glass and the scanner glass.
When you scan transparent materials, choose the Home Mode or Professional Mode in Epson Scan.
|
 |
Open the Transparency Unit.
|
 |
Place the film in the appropriate holder.
|
See the following sections for details on the different types of film.
 |
Place the film holder on the scanner glass, aligning it with the notch on the transparency guide. Make sure the glossy side of the film is facing down.
|
 |
Close the Transparency Unit. If the reflective document mat is installed on the Transparency Unit, remove it; for details, see Installing the Transparency Unit.
|
Use your scanner software to scan the film.
Note:|
Make sure the Transparency Unit is completely closed; otherwise, an error occurs and you cannot scan.
Store the reflective document mat in the pocket on the top of the Transparency Unit when not in use.
|
35 mm film strips
|
Place the 35 mm film holder on a flat surface, and then remove a strip cover.
|
|
Insert the film facedown in the holder.
|
|
Replace the strip cover that you removed in step 1. Repeat steps 1 through 3 for all the filmstrips you want to scan.
|
|
Place the film holder on the scanner glass and align it with the notch on the transparency guide as shown below.
|
Mounted slides
|
Load slides facedown in the Mounted slide holder, as shown below. Repeat this step for all the slides you want to scan.
|
|
Place the slide holder on the scanner glass. Align the slide holder with the notch on the transparency guide, as shown below.
|
Medium format (120/220)
|
Place the Medium format holder on a flat surface, and then open a strip cover.
|
|
Insert the film facedown in the holder.
|
|
Close the cover. Repeat steps 1 through 3 for all the film you want to scan.
|
|
Place the film holder on the scanner glass and align it with the notch on the transparency guide, as shown below.
|
4 x 5 inch film
|
Place the 4 × 5 inch film holder on a flat surface, and then open a cover.
|
|
Insert the film facedown in the holder.
|
|
Close the cover. Repeat steps 1 through 3 for all the film you want to scan.
|
|
Place the holder on the scanner glass and align it with the notch on the transparency guide, as shown below.
|
Non-standard film sizes
Place the film directly on the scanner glass, making sure the glossy (smooth) side of the film is facing down.
If the reflective document mat is installed in the Transparency Unit, remove it. Close the Transparency Unit.
Note:|
An area approximately 17.0 mm (0.7 in) from the horizontal edges and 2.0 mm (0.1 in) from the vertical edges of the scanner glass cannot be scanned.
When you place the film directly on the scanner glass, make sure to set the focus position to 0.0 in Epson Scan.
|