|
|
Product Information / Product Specifications
Parallel interface
USB interface
Optional USB Cable
Your Stylus Scan is equipped with an 8-bit parallel interface and a USB interface.
The built-in parallel interface has the following characteristics.
Data format |
8-bit parallel, IEEE-1284 compatibility mode, IEEE-1284 ECP mode |
Synchronization |
STROBE pulse |
Handshake timing |
BUSY and ACKNLG signals |
Signal level |
TTL compatible |
Connector |
57-30360 Amphenol connector or equivalent |
Transmission mode |
IEEE-1284 Nibble mode, IEEE-1284 ECP mode |
Adaptable connector |
57-30360 Amphenol connector or equivalent |
Synchronization |
Refer to the IEEE-1284 specification |
Handshaking |
Refer to the IEEE-1284 specification |
Signal level |
IEEE-1284 Level 1 device |
Data transmission timing |
Refer to the IEEE-1284 specification |
The Stylus Scan's built-in USB interface is based on the standards specified in the Universal Serial Bus Specifications Revision 1.0 and the Universal Serial Bus Device Class Definition for Printing Devices Version 1.0. This interface has the following characteristics.
Standard |
Based on Universal Serial Bus Specifications Revision 1.0, Universal Serial Bus Device Class Definition for Printing Devices Version 1.0 |
Bit rate |
12 Mbps (full speed device) |
Data encoding |
NRZI |
Adaptable connector |
USB Series B |
Recommended cable length |
2 meters |
The specifications below apply to the optional USB cable (C83623).
USB Series A (4-pin) Plug Connector
USB Series B (4-pin) Plug Connector
1.8 meters long
Previous |
Next |
Version 1.00E, Copyright © 2001, SEIKO EPSON CORPORATION |