If only a partial computer image appears, try the
following solutions:
- For VGA connections, press the Auto button on the remote control to optimize
the image signal.
- Make sure you selected the correct Screen Type setting in the projector's
Installation menu for the screen you are using. If there are
margins between the edge of the image and the projected screen
frame, use the Screen Position
setting to adjust the position of the image.
- Make sure the Scale setting in the Image menu is turned
off.
- Make sure the Resolution setting in the Image menu is set
correctly for the input signal.
- Try adjusting the image position using the
Position setting in the Image
menu.
- Press the
Aspect button on the remote
control to select a different image aspect ratio.
- If you
zoomed into or out of the image using the E-Zoom buttons, press the Esc button until the projector returns to a
full display.
- Check your
computer display settings to disable dual display and set the
resolution within the projector's limits. (See your computer manual
for details.)
- Check the
resolution assigned to your presentation files to see if they are
created for a different resolution than you are projecting in. (See
your software help for details.)
- Make sure you selected the correct Projection setting in the Installation
menu.
- If you are projecting in Content Playback mode, make sure you are
using the correct Overlay Effect
setting in the Operation > Content Playback menu.