To set up
your projector for monitoring and control using a Crestron
Connected system, make sure your computer and projector are
connected to the network.
Note: If you
want to use the Crestron Connected system when the projector is
turned off, you need to adjust the Standby Mode setting in the
Operation menu. The Standby Mode setting is displayed only if the
A/V Output setting in the Signal I/O menu is set to While Projecting, the Auto Power On setting
in the Network menu is set to Off, and the Power On Trigger setting in the
Operation menu is set to Plug-in
Detection.
- Press the Menu button.
- Select the Network menu
and press
Enter. - Select Network Settings and press Enter.
- Select the Projector Control menu and press Enter.
- Set the Crestron
Connected setting to On to
allow the projector to be detected.
Note: Enabling Crestron Connected disables the Message Broadcasting feature in the Epson Projector Management software.
- When you are finished selecting settings, select
Return and press Enter to return to the Network Settings menu.
- Select Set, and follow the on-screen instructions to save your settings and exit the menus.
- Turn off the projector, then turn it on again to enable the setting.